Removing The Unit - Kenwood DDX6023BT Instruction Manual

Removing the Unit

(DDX4023BT/DDX4053BT/
DDX3023/DDX3053/
DDX42BT/DDX35 only)
• For removing DDX6023BT/DDX6053BT,
1 Remove the trim plate by referring to
the removal procedure in the section
"Removing the Trim Plate".
2 Insert the two extraction keys 4 deeply
into the slots on each side, as shown.
3 Lower the extraction keyl toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
⁄
• Be careful to avoid injury from the catch pins on
the removal tool.
4 Pull the unit all the way out with your
hands, being careful not to drop it.
78
English
Installing the Microphone
Unit (DDX6023BT/
DDX6053BT/ DDX4023BT/
DDX4053BT/DDX42BT only)
☞
page 73. 1 Check the installation position of the
2 Remove oil and other dirt from the
3 Install the microphone.
4 Wire the microphone cable up to the unit
Accessory 4
⁄
• Install the microphone as far as possible from the
Peel the release coated paper of double-face
adhesive tape to fix on the place shown above.
Adjust the direction of the microphone to the
driver.
microphone (accessory 7).
installation surface.
with it secured at several positions using
tape or the like.
mobile phone.
Accessory 7
Fix a cable with clamps (commercially
available).