3-1. Installation of Indoor Unit
3-1-1. Removing the Front Panel
(1) Open the screw caps and remove the two screws
securing the front panel.
Fig. 3-1 Opening the screw cap
Caution When Connecting the Connecting Cable
When connecting the connective cable, follow the
instructions below.
(1) Remove the front panel.
3. CAUTION IN INSTALLATION
Fig. 3-3
(2) Close the screw caps as behind.
(3) Open the air outlet direction (up-down) louver hori-
zontally by hand.
(4) Slightly open the lower part of the front panel,
then pull the upper part of the front panel toward
you to remove it from the rear plate.
Fig. 3-2 Removing the front panel
Note:
•
Connect the indoor and outdoor units with a
connective cable over the shortest distance as
possible.
– 8 –
Fig. 3-4