Toshiba RAS-07EKH Service Manual page 26

8-9-2. Adjusting the Horizontal Air Flow
Direction
Preparation:
For the cooling or dry operation, move the vertical air
flow louver downward using the SET button on the
remote controller.
(1) Take hold of the lever on the horizontal air flow
grilles and move them to adjust the air flow direc-
tion as required.
Fig. 8-18
(2) You can adjust the air flow at the left, right loca-
tions of the grilles.
(3) For the cooling or dry operation, return the verti-
cal air flow louver to the original position using
the SET button on the remote controller.
Fig. 8-19
8-9-3. Adjusting the Automatic Swing Air Flow
Direction
Perform this function while the air conditioner is in
operation.
(1) Push the AUTO button on the remote controller.
(2) To stop the function, push the AUTO button again.
(3) To change the swing direction, push the SET but-
ton.
CAUTIONS:
• The SET and AUTO buttons will be disabled
when the air conditioner is not in operation (in-
cluding when the ON TIMER is set).
• Do not operate the air conditioner for long hours
with the air flow direction set downward during
the cooling or dry operation. Otherwise, con-
densation may occur on the surface of the ver-
tical louver and cause dew dripping.
• Do not move the vertical louver manually. Al-
ways use the SET button. If you move the lou-
ver manually, it may malfunction during opera-
tion. If the louver malfunctions, stop the air con-
ditioner once, and restart.
• When the air conditioner is started immediately
after it was stopped, the vertical louver might
not move for 10 seconds or so.
• The angle of the two vertical louvers may dif-
fer when they move downward and upward.
– 26 –
Fig. 8-20