To Support The Unit; Detaching The Front Panel; Attaching The Front Panel; Cleaning The Connector - Caliber MCD065 Instruction Manual

TO SUPPORT THE UNIT

Dashboard
2
10
Detaching and attaching the front panel
The front panel of this unit can be detached in order to prevent the unit
from being stolen.

DETACHING THE FRONT PANEL

Before detaching the front panel, be sure to press the
power off first. Then press the button
it towards you as illustrated

ATTACHING THE FRONT PANEL

Make sure the front panel is in the right way up when attaching it to the unit as it cannot be attached upside
down. Bring side B of panel to side A of main unit.
Insert the panel in and push until it clicks. Panel is attached.
Notes:
• Do not press the front panel hard against the unit when attaching it.
It can be easily attached by pressing it lightly against the unit.
• When you carry the front panel with you, put it in the supplied front
panel case.
• Do not press hard or give excessive pressure to the display window
of the front panel when attaching it to the unit.

CLEANING THE CONNECTOR

The unit may not function properly if the connectors between the
unit and the front panel are contaminated with dirt. In order to
prevent this from happening, detach the front panel by pressing
the button and clean the connector from time to time.
Clean the connector with a cotton swab together with contact
cleaner as illustrated. Be sure to clean them carefully pin by pin
and make sure not to damage the connecting points.
3
4
5
1
and detach the panel by pulling
B
A
4
6
8
9
button to
B
A
EN-
. UNIT
. RELEASE CASE
. DASH BOARD
4. HEX NUT
5. LOCK WASHER
6. PLAIN WASHER
7. CAR BODY
8. REAR SUPPORT STRAP
9. TAPPING SCREW
0. M5 X 5 HEX BOLT
7
4
5
6
Main unit
Rear of
front panel
Cotton Swab
B
A