Panasonic KX-TGF380 Operating Instructions Manual page 76

Useful Information
CAUTION:
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate this
device.
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Some cordless telephones operate at frequencies
that may cause interference to nearby TVs and
VCRs. To minimize or prevent such interference,
the base of the cordless telephone should not be
placed near or on top of a TV or VCR. If
interference is experienced, move the cordless
telephone further away from the TV or VCR.This
will often reduce or eliminate interference.
FCC RF Exposure Warning:
R This product complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.
R To comply with FCC RF exposure
requirements, the base unit must be installed
and operated 20 cm (8 inches) or more between
the product and all person's body.
R This product may not be collocated or operated
in conjunction with any other antenna or
transmitter.
76
TGF38x(en)_1205_ver101.pdf 76
For assistance, please visit www.panasonic.com/support
R The handset may be carried and operated with
only the specific provided belt-clip. Other
non-tested belt-clips or similar body-worn
accessories may not comply and must be
avoided.
Notice:
R FCC ID can be found inside the battery
compartment or on the bottom of the units.
Compliance with TIA-1083 standard:
Telephone handsets identified with this logo have
reduced noise and interference when used with
T-Coil equipped hearing aids and cochlear
implants.
Compatible with
Hearing Aid T-Coil
TIA-1083
Charge only mode
The charge only mode is the dedicated mode to
charge the backup batteries of the base unit. Do
not use this mode if it is unnecessary because all
functions except the base unit's battery charge is
disabled with this feature on. Leave all the
registered handsets on the chargers during use of
the charge only mode.
n To activate the charge only mode:
1
Disconnect the telephone line cord, the AC
adaptor plug, and remove the batteries from
the base unit with the corded handset
placed on the cradle.
2
Press and hold 3, MZN, and MHOLDN at the
same time, then insert the AC adaptor plug
to the base unit.
Keep on pressing these keys until:
– a beep tone sounds, and
– and the SP-PHONE indicator once
turn on and off.
3
Release these keys.
R LCD turns off.
4
Insert batteries.
R The batteries are started to be charged.
Note:
R If the LCD is still on when you release the keys,
the base unit is not in the charging only mode.
Repeat from step 1. The charge only mode is
2014/12/05
T
10:20:16