Panasonic KX-TGF380 Operating Instructions Manual page 18

Link to Cell
Important:
R When 3 Bluetooth devices (2 cellular phones
and 1 headset) are paired to the base unit, only
2 Bluetooth devices can be used with the unit at
the same time, and the base unit loses its
connection from other Bluetooth devices. To
automatically resume the connection to
Bluetooth devices, leave the auto connection on.
R Some cellular phones lose connection after
usage, please check the specifications of your
cellular phone for more details.
Handset / Base unit
1
MMENUN#632
2
MbN: Select the desired setting. a MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Note:
R Some cellular phones may ask you if you accept
the connection requirement from the base unit.
In that case, select "Off" in step 2. Check the
specifications of your cellular phone.
Connecting/disconnecting the cellular phone
manually
If you will not be using the paired cellular phone's
link to cell feature temporarily (for example, you do
not want the unit to ring when your cellular line
receives a call), you can disconnect your cellular
phone from the base unit. If you want to use it
again, reconnect the cellular phone to the base
unit.
You can configure this setting using either the
base unit or one of the handsets.
Note:
R After you disconnect a paired cellular phone
from the base unit manually, it will automatically
be connected to the base unit in 30 minutes. If
you do not use the link to cell feature anymore,
unpair the cellular phone (page 17).
R A disconnected cellular phone is not unpaired
from the base unit, so pairing it to the base unit
again is unnecessary.
Handset / Base unit
1
To connect/disconnect:
For CELL 1: MMENUN#6251
For CELL 2: MMENUN#6252
R A long beep sounds.
18
TGF38x(en)_1205_ver101.pdf 18
For assistance, please visit www.panasonic.com/support
2
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Cellular line only mode (If you do not
use the landline)
If you do not use the landline, we recommend
setting the unit to the cellular line only mode.
The default setting is "Off".
You can configure this setting using either the
base unit or one of the handsets.
Important:
R If you turn on the "Cell line only mode",
disconnect the telephone line cord from the
base unit. Otherwise the "Cell line only
mode" cannot be activated.
Handset / Base unit
1
MMENUN#157
2
To turn on:
MbN: "On" a MSELECTN a MbN: "Yes" a
MSELECTN
To turn off:
MbN: "Off" a MSELECTN
Note:
R Once you set this mode, you can use the
following buttons to make cellular calls:
– for the handset, press M
MCELLN (page 20).
– for the base unit, lift the corded handset or
press MZN without pressing MCELL 1N or
MCELL 2N set for the cellular line selection
(page 19, 24).
R Once you set this mode, the following features
cannot be used:
– Landline features (page 44)
– Answering system (page 57)
Messages cannot be received.
– Voicemail features (page 64)
R After this mode is turned on or off, the base unit
reboots.
– Bluetooth connections from cellular phones or
headset are disconnected. If the auto
connection is turned on (page 17), the cellular
phones are reconnected.
– will be displayed on the handset
momentarily. The handset can be used once
is displayed.
2014/12/05
N or MZN instead of
10:20:12