Making Adjustments And Selections - Panasonic PT-VW350 Operating Instructions Manual

Initial setting (standby mode)
Item
[STANDBY MODE]
1) Press qw to switch the setting.
2) Press the <ENTER> button.
f Confirm the setting value and complete the initial setting.
Note
f If you press the <RETURN> button while the initial setting screen is displayed, you can go back to the previous screen.
f The above initial setting screen is the one displayed when the projector is switched on for the first time after purchase.
When [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed, the setting of [STANDBY MODE] before execution is
displayed.

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
1) Adjust the focus of the image roughly. (x page 40)
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 70)
f Refer to "Navigating through the menu" (x page 47) for the operation of the menu screen.
3) Press the <INPUT SELECT> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <S-VIDEO>) buttons on the remote control to select the input
signal.
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 29)
5) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
38 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
Set the operation mode during standby.
f The default setting is [ECO] that keeps power consumption low during
standby.
f Set to [NORMAL] to use the network function or the serial communication
function during standby.
f Set to [NETWORK] to reduce power consumption during standby, and to
operate the projector via the wired LAN or the serial communication function
by using the Wake on LAN function.
After completed the initial setting, you can change the setting from the [PRO-
JECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
Description Page
72