Mounting The Access Point - EnGenius EWS860AP The Neutron Series User Manual

Mounting the Access Point

Using the provided hardware, the Access Point can be attached to a ceiling or wall.
To attach the Access Point to a wall using the wall mounting kit:
1. Mark the four locations of the mounting holes on the flat mounting surface.
2. Drill a 1.46" (37mm) deep .31" (8 mm) hole in the markings and hammer the bolts into the openings.
3. Place the lock and flat washers on the four hex cap screws and drive the screws to attach the bracket to the back of the Access Point.
4. Tighten the flat washers to secure the bracket to the mounting surface.
30