Configuring Snmp User - ZyXEL Communications GS3700 Series User Manual

The following table describes the labels in this screen.
Table 208 Management > Access Control > SNMP > Trap Group > Port
LABEL
Option
Slot
Port
1/*
Active
Apply
Cancel

44.3.7 Configuring SNMP User

From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 321 Management > Access Control > SNMP > User
Chapter 44 Access Control
DESCRIPTION
Select the trap type you want to configure here.
Select the slot number that represents the Switch in a stack.
This field displays a port number. In stacking mode, the first number represents the slot
and the second the port number.
Settings in this row apply to all ports for the Switch represented by the slot ID (in stacking
mode).
Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the sending of SNMP traps on this port. The Switch sends
the related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
422