Contents
Connections
Using as a D/A converter
Connect and playback from a digital
device (Optical)
1
Press the input source select button (OPTICAL) to
switch the input source to "Optical".
The digital audio signal that is being input is shown as follows in the
display.
(xxxx is the sampling frequency.)
If the sampling frequency cannot be detected, "Signal Unlock" will
0
be displayed.
"Unsupported" is displayed when audio signals that are not
0
supported by this unit are input.
Front panel
Rear panel
Playback
Optical
PCM xxxkHz
Remote control
unit
Settings
o Files that can be played back
See "D/A converter" (v p. 115).
NOTE
0 Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
0 If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
81
Index
Tips
Appendix