Table of Contents
Advertisement
Settings 2 Menu
Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the
Settings 2 menu. Press the cursor ▲▼ button to move up and down in the Settings 2 menu.
I
TEM
Auto Source
No Signal Power
Off (min.)
Auto Power On
Lamp Mode
Reset All
Status
Advanced 1
Advanced 2
Press the cursor ◄► button to enter and enable or disable automatic source
detection.
Press the cursor ◄► button to enter and enable or disable automatic shutdown of
lamp when no signal.
Press the cursor ◄► button to enter and enable or disable automatic power On when
AC power is supplied.
Press the cursor ◄► button to enter and select the lamp mode for higher brightness
or lower brightness to save lamp life.
Note:
Remarks to Dynamic ECO of ImageCare
1. Shut-down is not allowed when the projector is boot up less than one minute
2. To protect the lamp, when a shut-down command is received, the lamp mode is forced to be
reset to "Normal" and the system will automatically shut down 10 seconds later
(Enter) / ► to reset all settings to default values.
Press
(Enter) / ► to enter the Status menu. See page
Press
Status.
(Enter) / ► to enter the Advanced 1 menu. See
Press
page 35.
(Enter) / ► to enter the Advanced 2 menu. See
Press
page 47.
D
ESCRIPTION
TM
– 33 –
34
for more information on
Advanced 1 Feature
on
Advanced 2 Feature
on
Advertisement
Table of Contents
