Canon MB2000 series Online Manual page 275

3. Use the
4. Use the
5. Use the
If you do not use the machine over wireless LAN, select Disable LAN.
Setting of the Access Point Mode
Specify the settings for the access point mode following the procedure below.
1. Make sure that the machine is turned on.
2. Select
LCD and Operation Panel
3. Select
4. Use the
5. Use the
6. Use the
The screen to enter the access point name (SSID) is displayed.
7. Enter the access point name (up to 32 characters).
Enter the access point name when you use the machine as an access point.
8. Press the OK button to finish entering the name.
9. Use the
Disable
Finishes the access point settings without specifying the security setting.
WPA2-PSK (AES)
Specifies the security setting applying WPA2-PSK (AES). Proceed to the next step when the
screen to specify the password is displayed.
10. Enter the password (8 to 10 characters).
11. Press the OK button to finish specifying the password setting.
Downloaded from ManualsPrinter.com Manuals
button to select LAN settings, then press the OK button.
button to select Change LAN, then press the OK button.
button to select Wireless LAN active, then press the OK button.
Setup on the HOME screen.
Device settings, then press the OK button.
button to select LAN settings, then press the OK button.
button to select Other settings, then press the OK button.
button to select Access point mode settings, then press the OK button.
button to select the security setting, then press the OK button.
275