Displaying The Preview Screen - Canon MB2000 series Online Manual

Displaying the Preview Screen

Pressing the center Function button allows you to preview an image of the printout on the preview screen.
Important
• The preview screen is not available when you load the original in the ADF.
• In the following conditions, you cannot use the left Function button when the Copy standby screen is
displayed.
• 2-sided is selected for 2-sidedPrintSetting.
• 2-on-1 copy or 4-on-1 copy is selected for Layout.
• ON is selected for Collate.
When either of the conditions above is selected, you can set to display the preview screen after
scanning the original is finished.
When 2-sided, 2-on-1 copy, or 4-on-1 copy is selected and the original is loaded on the platen
glass, you can set to display the preview screen after scanning the original is finished.
Two-Sided Copying
Copying Two Pages to Fit onto a Single Page
Copying Four Pages to Fit onto a Single Page
Collated Copying
• The original will be scanned to display the preview image. Therefore, do not open the document cover
until the preview screen is displayed.
• Originals are rescanned after displaying the preview screen and before copying starts. Therefore, do
not open the document cover or remove the original from the platen glass while Scanning document...
is displayed.
1. Preview of the original
The original that is set on the platen glass is displayed. If the displayed image is skewed, refer to
Loading Originals
original.
2. Page size
A frame showing the selected page size appears over the image. The inside of the frame will be printed.
3. Magnification
The magnification setting, which was set when the preview screen was displayed, is displayed. If the
setting other than Fit to page is selected, you can change the magnification setting using the
button.
Downloaded from ManualsPrinter.com Manuals
and reset the original properly, then display the preview screen again and preview the
534