Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch GSG 300 Professional Original Instructions Manual

Technical Data

Foam rubber cutter
Article number
Rated power input
Output power
Stroke rate at no load n
Stroke speed under load
Cutting capacity, max.
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is 79 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value a
2
ty K =1.5 m/s .
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
Bosch Power Tools
GSG 300
Professional
0 601 575 1..
W 350
W 185
spm 3200
0
spm 2100
mm 300
kg 1.6
/ II
2
=2.5 m/s , Uncertain-
h
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
19.12.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Before any work on the machine itself, pull
the mains plug.
Mounting the Saw Blade Guide
(see figure A)
Remove the screws 5 from the housing. Attach
the saw blade guide 2 onto the housing in such a
manner that the mounting pins engage into the
corresponding holes and secure with the screws
5.
English | 15
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 N74 | (25.1.08)