Table of Contents
Advertisement
OBJ_BUCH-3345-001.book Page 7 Tuesday, October 17, 2017 12:15 PM
8 Clamping lever of the depth stop
9 Depth stop
10 Plunge saw blade*
11 Hex screw
12 Hex key
13 Handle (insulated gripping surface)
14 Dust extraction*
15 Sanding plate*
16 Sanding sheet*
17 Clamping lever of the dust extraction
18 Vacuum connection*
19 Extraction adapter*
20 Vacuum hose*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Cordless Multi-Cutter
Article number
Rated voltage
No-load speed n
0
Oscillation angle, left/right
Weight according to
1)
EPTA-Procedure 01:2014
Permitted ambient temperature
– during charging
2)
– during operation
and during
storage
Recommended batteries
Recommended chargers
1) depending on the battery pack being used
2) limited performance at temperatures <0 °C
Technical data determined with battery from delivery scope.
Assembly
Battery Charging
Use only the chargers listed in the technical data. Only
these chargers are matched to the lithium-ion battery of
your power tool.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
Bosch Power Tools
Removing the battery
To remove the battery 3, press the unlocking buttons 2 and
pull the battery out of the machine to the rear. Do not exert
any force.
Battery Charge-control Indication
The three green LEDs of the battery charge-control indicator
6 show the charging status of the battery 3. The battery
charge-control indicator only illuminates for 5 seconds after
start-up.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Flashing light 3 x green
When no LED lights up after switching on, then the battery is
defective and must be replaced.
GOP 10,8V-28
Changing the Tool
3 601 HB5 0B.
Before any work on the machine itself (e.g. mainte-
10.8
V=
nance, tool change, etc.) as well as during transport
-1
min
5000–20000
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
°
1.4
the On/Off switch.
Wear protective gloves when changing application
kg
0.97–1.2
tools/accessories. Contact with the application tool/
accessory can lead to injuries.
°C
0...+45
Selecting the Application Tool/Accessory
°C
–20...+50
Accessory
GBA 10,8V...
GBA 12V...
GBA 12V... W
AL 11.. CV
GAL 12.. CV
GAL 18... W
English | 7
Capacity
≥2/3
≥1/3
<1/3
Reserve
Empty
GOP 10,8V-28
1 609 92A 457 | (17.10.17)
Advertisement
Table of Contents
