Setting The Label Size And Paper Layout For Borderless Printing; Requirement; Setting Example - Epson TM-C3500 Series Technical Reference Manual

Setting the label size and paper layout for bor-
derless printing
This section explains the approaches for borderless printing and how to set the paper size and
layout.
Apply the settings when designing the label paper, making the driver settings, and setting the
data size on the application.

Requirement

• To perform borderless printing, set the print area bigger than the actual label size by 1.5 mm
on all sides.
• Select [Borderless Printing].
• Labels are half-cut, and fringes are not removed except for the left and right edges.
• The positions of the labels are detected by black marks as there are no gaps between labels.
• Select [Continuous Paper (BlackMark)] for Media Form.
• Set and print black marks at 1.5 mm above the tip of the label on back side.
• The dotted red lines in the following illustration show the print area specified in [User
Defined Media Layout] in the printer driver.
• The example shows the label paper with one label placed sideways along the paper width.

Setting example

• Label size
Width: 60.0 mm
Length: 35.0 mm
• Printer driver's [User Defined Media Layout] settings
Media Form: Continuous Paper (BlackMark)
Borderless Printing: Check
Media Width: 63.0 mm
BlackMark Interval: 38.0 mm
 Use the same approaches when creating label other than square-shaped.
 Depending on the label shape, the label may peel off from the backing paper inside the
172
printer. Check the label thoroughly before use.