Troubleshooting - Westinghouse 10KPRO Owner's Manual

TROUBLESHOOTING

TROUBLESHOOTING
WARNING
Before attempting to service or
troubleshoot the generator, the owner
or service technician must first read
the owner's manual and understand
and follow all safety instructions.
Failure to follow all instructions may
result in conditions that can lead to
voiding of the EPA certification or
product warranty, serious personal
injury, property damage or even death.
PROBLEM
Engine is running, but no
electrical output.
Engine will not start or
remain running while trying
to start.
50
POTENTIAL CAUSE
1. Circuit breakers are tripped.
2. The ground fault sensor is
tripped.
3. The power cord's plug
connector is not fully engaged
in the generator's outlet.
4. Faulty or defective power cord
5. Faulty or defective electrical
appliance
6. If trying 1-5 above does not
solve the problem, the cause
might be the generator has a
fault.
1. Fuel shutoff valve is in the OFF
position.
2. Generator is out of gasoline.
3. Fuel flow is obstructed.
4. Starting battery may have
insufficient charge
5. Dirty air filter
6. Low oil level shutdown switch
is preventing the unit from
starting.
7. Spark plug boot is not fully
engaged with the spark plug tip.
8. Spark plug is faulty.
9. Stale fuel
10. If trying 1-9 above does not
solve the problem, the cause
might be the generator has a
fault.
SOLUTION
1. Reset the circuit breakers and check for overload
condition (see page 30).
2. Reset the ground fault sensor (see page 46).
3. Verify plug connector is firmly engaged in the
generator's outlet. If using the 240V outlet, make sure
plug connector is rotated 1/4 turn in the clockwise
direction.
4. Replace power cord.
5. Try connecting a known good appliance to verify the
generator is producing electrical power.
6. Take the generator to your nearest authorized
service dealer.
1. Move the fuel shutoff valve to the ON position (see
page 31).
2. Add gasoline to the generator (see page 28).
3. Inspect and clean fuel delivery passages.
4. Check battery output and charge battery as
necessary.
5. Inspect and replace the air filter (see page 39).
6. Check oil level and add oil if necessary (see pages
35 and 36).
7. Firmly push down on the spark plug boot to ensure
the boot is fully engaged (see page 42).
8. Remove and check the spark plug. Replace if faulty
(see page 42).
9. Drain fuel and replace with fresh fuel (see page
28).
10. Take the generator to your nearest authorized
service dealer.