Assembly - Westinghouse 10KPRO Owner's Manual

ASSEMBLY

Before assembling the generator,
review Safety on page 7 and the
following safety messages.
CAUTION
Never lift the generator without
assistance. The generator is heavy and
lifting without assistance could result
in personal injury.
Never use the handles as a lifting
point to support the entire weight of
the generator. Only use the handles
to move the generator by lifting the
handles and using the wheels to move
the generator.
Use caution when collapsing the
handles. Hands and fingers could get
caught and pinched.
NOTICE
Assembling the generator will require lifting the unit.
Make sure all engine oil and fuel are drained from the
unit prior to assembling.
Once assembled, the wheel kit is not intended for
on-road use. The wheel kit is designed for use on this
generator only.
Tools required – tool bag (included).
1. Place generator on a flat surface.
2. Using a block of wood, raise and support the back
of the generator.
ASSEMBLY
3. Install the mounting foot to the frame using M8
flange bolts and nuts (see Figure 6).
1
2
Figure 6 – Assemble Mounting Foot to Frame
1 - M8 Flange Bolt
2 - M8 Flange Nut
4. Install the 12 mm x 1.5 mm axle bolt through the
axle bracket on the frame.
5. Install the flange nut and tighten (see Figure 7).
1
3
Figure 7 – Assemble Wheels to Frame
1 - Flange Nut
2 - Wheel
3
3 - Mounting Foot
2
3 - Axle Bolt
15