Table of Contents
Advertisement
DANGER: To avoid electric shock
1. Do not change the power cord and
plug to another specification not
provided by the manufacturer.
2. Do not use in rain or where floor is
wet. This tool is intended for indoor
residential use only.
Motor Safety Protection
CAUTION: To avoid motor damage, this
motor should be blown out or vacuumed
frequently to keep sawdust from
interfering with normal motor ventilation.
1.
Connect this tool with a fuse or circuit
breaker. Using the wrong size fuse can
damage the motor.
2.
If the motor does not start, press the stop
button down immediately. UNPLUG THE
TOOL. Check the saw blade to make sure
it turns freely. If the blade is free, try to start
the motor again.
3.
If the motor still does not start that have to
check the motor's carbon brushes which
can be used 600~800 hours if carbon
brushes has been worn, please change the
new one.
4.
If the motor suddenly stalls while cutting
material, press the stop button off, unplug
the tool, and free the blade from the steel
Then you may restart the motor and finish
the cut.
5.
Fuses may "blow" or circuit breakers may
trip frequently if:
a.
Motor is overloaded-overloading can
occur if you feed too rapidly or make
too many start/stops in a short time.
b.
Voltage not more than 10% above or
below the nameplate voltage can
handle normal loads. For heavy loads,
however, the voltage (caused by a
small size wire in the supply circuit or
an overly long supply circuit wire) may
drop too low for the motor to operate.
Always check the connections, the
load and the supply circuit whenever
motor does not work well. Check wire
sizes and length with the Wire Size
Chart below.
6.
Most motor troubles may be trace to loose
or incorrect connections, overload, low
voltage (such as small size wire in the
supply circuit) or to overly long supply
circuit wire. Always check the connections,
the load and the supply circuit whenever
motor doesn't work well. Check wire size
and length with the Wire Size Chart below.
Wire Sizes
The use of any extension cable will cause some
loss of power. To keep this to a minimum and to
prevent overheating and motor burn-out, use the
table below to determine the minimum wire size
(lead cross-section) of an extension cable.
For circuits that are more than 40m away from
the electrical service box, the wire size must be
increased proportionately in order to deliver
ample voltage to the saw motor.
Length of the
Conductor
up to 15m
15-40m
5. Unpacking and Checking
Contents
The Metal Saw is shipped complete in one
carton. Separate all parts from packing material
and check each item with illustration and Make
certain all items are accounted for, before
discarding any packing material.
WARNING: If any parts are missing, do
not try to assemble the metal saw, plug
in the power cable or turn the switch on
until the missing parts are obtained and
installed correctly.
E
Item
Attached Parts
1
Stop Rod Assembly (E) Fig.4
2
Instruction Manual
- 6 -
Wire Sizes Required
For 220V
2
1.5mm
2
2.5mm
Fig. 4
Q'TY
1set
1
Advertisement
Table of Contents
