Top/Bottom Installation Configuration - Olimpia splendid INVERTER 9 SF Service Manual

5.3 Protection against internal heat-exchanger temperature too low:
This signal is communicated by 6 blinks red LED (HP mode); the temperature limit is 2°C and considerations are:
•
T°int. heat-exchanger ≥ 7°C
•
4°C < T°int. heat-exchanger < 6°C
•
3°C ≤ T°int. heat-exchanger ≤ 2°C
•
T°int. heat-exchanger < 1°C
6.

TOP/BOTTOM INSTALLATION CONFIGURATION

This unit may be installed either at the bottom of the wall (adjacent to the floor) or at the top (adjacent to the
ceiling). The air jet can be modified to optimize air distribution and room well-being by changing the position of
the air outlet flap and setting an appropriate temperature correction "T°camb." amounted to +3°C (it is not
possible to separate two operations).
which air flows upwards. The same configuration may also be used to install the unit near the ceiling with the
cooling function. This permits to increase the air flow inside the room (Coanda effect). Figure 2 refers to a machine
configured for installation near the ceiling in which air flows downwards.
After having carried out the mechanical operations to change the air outlet flap, configure the machine's control
electronics follows these points:
- connect the power supply line;
- ensure the machine is in standby;
- hold down the micro-button (H) until an audible signal starts ringing;
- CEILING CONFIGURATION: press the micro-button (H) to select yellow LED C;
- FLOOR CONFIGURATION: press the micro-button ( H) to select green LED D;
- release the micro-button;
- wait a few seconds until the standby configuration is restored ;
there's no frequency limitation;
the rate of frequency grow is limited;
the frequency stops growing;
the frequency starts going down;
Figure 1 refers to a machine configured for installation near the floor in