HP 8200i User Manual page 25

One Device
The OPTIONAL data cable that came with the
CD-Writer Plus drive is only used if there is no
cable already attached to the recommended
IDE controller in your computer system or
the cable supplied with your computer is not
long enough.
Use the connectors at the two ends of the
cable.
CD-Writer Plus
drive (on end connector)
Installing a CD-Writer
Two Devices
Attach the CD-Writer Plus to whichever
connector is not in use (center or end) on the
data cable already installed in your computer
(DO NOT swap connectors).
The OPTIONAL data cable that came with the
CD-Writer Plus is only used if there is no spare
connector for the CD-Writer Plus on your
cable or your cable is not long enough.
PIN-1
Drive
Unused connector
Colored stripe
aligned with
each PIN-1
IDE controller
located inside
your computer
PIN-1
Motherboard
PIN-1
Drive
CD-Writer Plus
drive (either location
PIN-1
Drive
Follow the
data cable
Colored stripe
already
aligns with
attached to the
each PIN-1
other IDE device
in your
computer to
locate the IDE
IDE controller
controller.
located inside
your computer
PIN-1
Motherboard
1-13
not in use)