Ricoh Sp 213Nw Setup Manual page 23

Configuring the IPv4 Address Settings Using the Smart
Organizing Monitor
On the [Start] menu, click [All Programs].
Click [Smart Organizing Monitor for SP xxx Series].
Click [Smart Organizing Monitor Status].
Click the [User Tools] tab.
Click [IP Address].
Enter the MAC address.
For the MAC address you need to enter, check the items on the configuration page. De-
pending on your connection method, the item you need to check on the configuration page
varies.
For Ethernet connection
Interface Information
For wireless connection
Wireless Status
Enter the IP address you want to change.
The computer's IP address can be ascertained using Command Prompt. To display the IP
address, open Command Prompt, enter "ipconfig", and then press the [Enter] key.
Enter the IP address of the computer being used with the variable part in the IP address
modified.
Specify the subnet mask and default gateway address as required in accordance with the
network environment.
Click [OK].
If the configuration is successful, the message "IP Address has been set well." appears.
If the configuration fails, the message "Setting IP Address failed. Try again." appears. If this
happens, repeat the procedure from Step 6.
Click [OK].
Click [Close].
23
© 2014
EN TW M215-8630