5.3 Discovery AP
Configure Discovery AP, go to: Access Points >> Discovery.
After AP template configuration is finish, use this function to detect and manage all of the APs in the
network segments. Note that AMG-2001 can only manage APs that are connected to its LAN ports.
Therefore, the AP discovery function is for adding locally connected APs to its management list. The
administrator must know the local IP addresses of the APs he/she wishes to discover. Or the better way
is reset the AP to default setting for discovery.
To discover AP:
AP Type: Choose the type of AP you wish to discover.
Interface: Set to default.
Admin Settings Used to Discover: Choose from Factory Default or Manual, if the AP is
not using the default IP.
Then click the Scan Now button and the APs match the given settings will show in the list below. If one
of the IP addresses intended is used, a warning message will show up. In this case, please change the
IP range and then click Scan Now again.
AMG-2001
Access and AP Management Gateway
73
User's Manual