Connecting the USB memory
Remove the wireless LAN module before implementing the Easy Setup.
Set the roll paper beforehand to print the setting result.
If Easy Setup is not started, remove the USB memory, wait 30 seconds or more, then re-
1
Turn on the TM-DT.
2
Confirm that the status LED (orange) is off.
When you turn on the TM-DT, the status LED (orange) blinks, then turns off after a short
time. If turning on the printer for the first time, initial settings are executed inside the
device, so it will take some time for the status LED (orange) to turn off.
3
Connect the USB memory you prepared in Section 2.
4
When you connect the USB memory, setting processing is automatically
started. The status LED (orange) blinks during setting processing.
5
After setting processing is completed, the setting result is printed. Check
the printing result.
Refer to
"Checking the printing result" on page
28
insert the USB memory.
29.