Table of Contents
Advertisement
DHW cylinder installation
General information
¨ Safety instruction
Install the DHW cylinder in a
frost-protected and draught-free
room. Otherwise it must be drained
when not in use and there is a risk
of frost.
H Provide adequate clearance from
the wall so that the thermostat can
be operated (if installed).
Installing the DHW cylinder with an electric immersion heater
min. 650
Please note
!
The thermal insulation must
not be able to come into
contact with naked flames.
Exercise caution when welding
and soldering.
H Level the DHW cylinder with its
adjustable feet.
¨ Safety instruction
Never extend the adjustable feet
beyond a total length of 35 mm.
"Electric immersion heater"
installation instructions
Maintain the minimum clearance.
¨ Safety instructions
The unheated length of any threaded
immersion heater installed on site
must be at least 100 mm.
3
Advertisement
Table of Contents
