Wiring - Clarion CC4001U Owner Manual And Install Manual

Installing/Wiring the camera
■ Adjusting camera angle (example)
CAUTION
When the camera angle has been changed,
the range displayed by the image on the

6. WIRING

Wiring
① Lead the camera cable into the vehicle and align it along the vehicle weather stripping. Use the
supplied cable holders as necessary to fix the wires in place and prevent them from being pinched in
hinges or dampers.
② Using an optional extension cable, the camera cable can be installed under the vehicle floor (carpet).
Applying the cable holders
Align the gap in the cable holder with the
center of the cable.
Cable holders
Adjust the angle of
brackets A+B as
required by the
mounting position.
Mount the cable holder onto the vehicle body while twisting
the holder onto the cable. Use the supplied cleaner to remove
any dirt from the vehicle surface before installing.
monitor will change. Always confirm by
direct observation when backing.
Adjust horizontal angle
while confirming image on
monitor.
Fix the cable with adequate
looseness in this area to prevent
it from being stretched or
pinched in the hinge when the
rear gate is opened and closed.
Cable holders
Always introduce the cable into the
vehicle from the bottom (floor) side.
Introducing the cable from the door
top or side may lead to penetration
by water.
9
CC4001U