Connecting To A Monitor - Clarion CC4001U Owner Manual And Install Manual

Connecting to a monitor

Commercially available monitor
The connector is not waterproof.
Always mount the connector inside the
vehicle, away from exposure to water.
Camera
(inside)
(outside)
10
CC4001U
DC+12 V (Reverse gear) connection wire
Use the accessory Electro-Tap for connections.
① Place end of DC+12 V (Reverse gear) connection wire
against stopper, and fold back in direction of arrow.
② Pass the vehicle wire through and fold back in
direction of arrow.
Wire to
vehicle
Press firmly with pliers until
the connector latch fastens
securely.
RCA pin cable
(yellow)
Extension cable (7 m)
Note:
• See the the Instruction Manual supplied with the
monitor for information regarding wiring,
operation, and composition of the monitor unit.
Latch
Wire to
vehicle
Stopper
Wire to vehicle
DC+12 V (Reverse)
GND
DC+12 V
(Reverse gear)
connection wire
DC+12 V
(Reverse gear)
connection wire
(Fuse 0.5 A)