Canon Vixia HF R10 Instruction Manual page 156

Cannot record movies on this memory card
- Movies cannot be recorded on a 64 MB or smaller memory card. Use a recommended mem-
ory card ( 35).
Cannot record movies on this memory card Initialize only using the camcorder
- The memory card in the camcorder was initialized using a computer. Initialize the memory
card with this camcorder (
Change the battery pack
- Battery pack is exhausted. Replace or charge the battery pack.
Check the memory card
- Cannot access the memory card. Check the memory card and make sure it is inserted cor-
rectly.
- A memory card error occurred. The camcorder cannot record or display the image. Try remov-
ing and reinserting the memory card, or use a different memory card.
- You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card
( 35).
- If after the message disappears,
corder and remove and reinsert the memory card. If
recording/playback. If the problem persists, save your recordings (
memory card (
Could not add the scene(s) to the playlist
- One or more scenes could not be added to the playlist. The playlist can contain a maximum of
999 scenes. If the playlist includes scenes recorded in FXP mode, the maximum number of
scenes in the playlist may be less than 999. Delete some scenes from the playlist (
Do not disconnect the USB cable or the power source until you safely end the connection from
the computer. Cannot write data with this connection. To write data to the camcorder,
connect the compact power adapter then reconnect the camcorder and computer.
- The camcorder cannot be operated while it is not being powered by the compact power
adapter and is connected to a computer with the supplied USB cable. In addition, scenes can-
not be written back and music files cannot be transferred to the camcorder. To avoid corrupt-
ing the data in the camcorder's memory, use the computer's Safely Remove Hardware
function to end the connection and disconnect the USB cable before using the camcorder.
- To be able to write back scenes and to transfer music files to the camcorder, use the com-
puter's Safely Remove Hardware function to end the connection, disconnect the USB cable,
power the camcorder using the compact power adapter and only then connect it to the com-
puter again.
Do not disconnect the USB cable or the power source until you safely end the connection from
the computer. Connect the compact power adapter
- When the camcorder is in
USB cable, the camcorder cannot be operated. Disconnecting the USB cable or power source
while this message appears may result in permanent loss of the recordings in the camcorder.
Downloaded From VideoCamera-Manual.com Manuals
156
Additional Information
38).
appears in red, perform the following: Turn off the cam-
38).
mode and is connected to the computer with the supplied
turns back to green you can resume
111) and initialize the
80).