Power Connector Cable - HP Pavilion Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the system board (see
To remove the power connector cable:
1. Remove the Phillips PM2.5×3.0 screw (1) from the left hinge that sits above the power connector.
2. Rotate the hinge upward (2).
3. Pull the tab away from the connector (3), and then remove the power connector and cable (4) from the
computer.
Reverse this procedure to install the power connector cable.
Battery on page 29).
Optical drive on page
Bottom cover on page
System board on page
30).
34).
48).
Component replacement procedures
Spare part number
806746-001
53