Download Print this page

Rinse Aid; Setting Amount Of Rinse Aid - Siemens SN 56T595 Operating Instructions Manual

Hide thumbs


Table of Contents

Rinse aid

Rinse aid
a i d
R i n s e
As soon as the rinse-aid refill
indicator P is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
Downloaded from Manuals
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.

Setting amount of rinse aid

The amount of rinse aid can be set from
( :
Change this setting, only if streaks
(select lower setting) or water stains
(select higher setting) are left on the
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
: .... is indicated on the digital
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting :
5. Press programme button # until
the factory set value :
indicated on the digital display 8.
To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of :
reached, the display jumps back
2. Press START button )".
The set value is saved.
3. Close the door.
to :
. Please set rinse aid on
to obtain very good drying results
is already set in factory).
has been


Table of Contents