Advertisement
Left
D
D
D
D
D
D
D
D
D
D
Side burner
Remove plastic packaging from side burner valve. Remove side burner grate from vdfhin
side burner shelf.
Connect fiat igniter wire tip to the igniter pin on the side burner valve. (A & B)
Remove the 2 prednstalbd screws from the valve control stem and set them aside. (CI
Loosen the side burner to insert gas valve. To loosen, remove the two screws on front bracket
and loosen the rear bracket screws halfway. (D&E)
insert the gas valve into the side burner (F), and inse4 the valve control stem through the hole
in shelf fascia. (1)
Replace side burner front bracket and tighten in place with 2 previously removed screws. (G)
Tighten screws on back bracket. (H)
Install previously removed 2 screws .Note:Do not tighten these 2 screws until the bezel is attached
to fascia and valve face. (I}.
Attach bezel to facial and valve face with the installed screws .First attach one side key hole of
bezel to the screw ,then attach the other one to the other screw.Make sure the black mark faces
up. (J). Tighten the 2 screws. (K)
Pushcontrol knob onto side burner valve stem. (L) Replace side burner grate. (M)
Connect the round igniter wire tip to the pin on the "white electrode protruding from the bottom
of the side burner shelf. (N)
24 - 33577-41500319
Advertisement
