Table of Contents
Advertisement
Switching the salt refill
indicator / water softening
system off and on
Hold down the programme button B
and switch on the main switch
then release the buttons.
The illuminated button B and the
factory-set value
display flash.
To change the setting: press the
programme button B .
Each time the button is pressed, the set
value increases by one; when the value
is reached, the display jumps back
to
(the salt refill indicator / water
softening system has been switched
off).
Switch off the main switch
The set value is stored within the
device.
Approx. 4 litres of water are required to
regenerate the water softening system.
As a result, the water consumption per
rinse cycle increases by 0 to maximum
4 litres depending on the water hardness
setting.
Note
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
hardness.
Downloaded from DishWasher-Manual.com Manuals
,
1
on the digital
.
1
en
15
Advertisement
Table of Contents
