Download Print this page

Filling The Salt Dispenser; Salt Refill Indicator - Siemens SE 65M352 Instructions For Use End Installation

Hide thumbs

Advertisement

Table of Contents
en

Filling the salt dispenser

Salt must always be filled before the
appliance is switched on, so that excess
salt solution is immediately flushed away
to prevent corrosion.
Open the screw-type cap of the
compartment
24
Before using the appliance for the first
time, pour about 1 litre of water in the
salt container.
Then refill with salt (not cooking salt)
until the salt container is full
(max. 1.5 kg). When you refill the salt,
water is being displaced and drains off.
8
Downloaded from DishWasher-Manual.com Manuals
.
The LOW SALT indicator
panel will light up initially but will extinguish
again after a short period when the salt
solution has become sufficiently
concentrated.
When the control is set to
necessary to fill up with salt as none will
be consumed while the dishwasher is
operating. The LOW SALT indicator is
switched off. If the control is set between
and
, then salt must be added to
the dispenser.
Warning
Do not pour detergent into the container
for special salt. This would destroy the
water softener.

Salt refill indicator

As soon as the salt refill indicator
on the control panel, refill with salt
immediately before the next rinse cycle.
Depending on the washing frequency and
the hardness setting, the regeneration salt
may not have to be topped up for several
months.
on the front
5
, it is not
is lit
5

Advertisement

Table of Contents
loading