Mail - D-Link DCS-930L User Manual

Section 3 - Configuration
This section allows you to configure the e-mail notification settings for your camera.
SMTP Server
This is the domain name or IP address of your external e-mail server.
Address:
SMTP Server This is the port used by your external e-mail server.
Port:
Sender E-mail
This is the e-mail address of the account sending the camera snapshots.
Address:
Receiver E-mail
This is the e-mail address to send the snapshots to.
Address:
User Name: If the SMTP server uses authentication, you must enter your user name here.
Password:
This is the password that corresponds to your user name to connect to the SMTP
server.
For example, if you want to use Gmail by SSL-TLS for the e-mail notification, you can follow the setup
procedure as below:
Step 1 - Enter "smtp.gmail.com" in SMTP Server Address.
Step 2 - Change the SMTP server port number from 25 to 465.
Step 3 - Enter your gmail E-mail address in Sender E-mail Address.
Step 4 - Enter the destination E-mail address in Receiver E-mail Address.
Step 5 - Enter the user name required to access the SMTP server.
Step 6 - Enter the password required to access the SMTP server.
Step 7 - Select SSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail will be sent to the e-mail account listed above.
Note: You can also use STARTTLS which will use SMTP server port 587.
Note: If you want to use the Yahoo SMTP server, the SMTP server address will be different between
each registered region, and only supports using SMTP server port 465 for SSL-TLS.
D-Link DCS-930L User Manual

Mail

34