Electrolux XDEX75NZHS User Manual page 14

Electrical connection
This machine is designed to operate on a 230-240 V or 220-
230 V, single phase, 50 or 60 Hz (depending on country of
fi nal destination). Check that your domestic electrical installa-
tion can take the maximum load required (4,5 Kw) also taking
into account any other appliances in use.
Connect the machine to an earthed socket, in accordance
with current wiring regulations.
WARNING!
The manufacturer declines any responsibility for damage or in-
jury through failure to comply with the above safety precautions.
Should the appliance power supply cable need to be installed
or replaced, this must be carried out by our Service Center.
IMPORTANT!
The power supply cable must be accessible after installing
the machine. If the fl exible cord is provided without plug, the
appliance must be provided an accessible all pole disconnec-
tion. The nominal cross-sectional area of conductors must
have a value between 2,5mm
Installing power supply cord
1. Turn off power supply to outlet.
2. Remove the screw (1) securing the terminal block access
cover in the lower corner on the back of the dryer.
3. Slide cover upward approximately 1 mm and slowly pull it
away from the back panel.
IMPORTANT!
An electrical supply line fi lter is attached to the inside recess
of the terminal block access cover. The terminal block access
cover may be temporarily removed from the line fi lter in order
to ease installation of power supply cord.
14
2 2
- 4,0mm .
1
Access cover screw
2
Terminal block
3
Neutral ("N" terminal)
4
Earth/Ground (" " terminal)
5
Live ("L" terminal)
6
Internal ground (GREEN screw)
7
Strain relief
8
Terminal screw recovery slot
1
2
3
4
5
6
7
8