Environmental Concerns - Electrolux XDEX75NZHS User Manual

General Installation
1. Connect the exhaust duct to the outside exhaust system.
Use of a 100 cm clamp
is recommended to
connect the dryer to
the exhaust vent sys-
tem. Use metal foil tape
to seal all other joints.
2. Carefully slide the dryer to its fi nal position. Adjust one or
more of the legs until the dryer is resting solidly on all four
legs. Place a level on top of the dryer. The dryer MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability.

Environmental concerns

Packaging materials
The materials marked with the symbol
This means that they can be recycled by disposing of them
properly in appropriate collection containers.
Old appliance
Use authorised disposal sites for your old appliance. Help to
keep your country tidy!
The symbol on the product or on its packaging indicates
that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By
ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by in
appropriate waste handling of this product. For more detailed
information about recycling of this product, please contact
your local council, your household waste disposal service or
the shop where you purchased the product.
16
Be sure the power is off at a circuit breaker/fuse box before
plugging the power cord into an outlet.
3. Plug the power cord into a grounded outlet.
4. Turn on the power at the circuit breaker/fuse box.
5. Read the Use & Care instruction at the beginning of this
6. If you have any questions during initial operation, please
7. Place these instructions in a location near the dryer for
A wiring diagram and technical data sheet are located inside
the dryer console.
• Keep the lint screen clean and exhaust the dryer correctly.
are recyclable.
• Sort laundry properly and select proper temperature and
• Dry only full loads. Single items and small loads usually
• Avoid overloading, adding wet items to a partially dry load,
• Dry one load after another to take advantage of a warm
• Opening the door needlessly causes warm air to escape,
• If possible, use the dryer on low humidity days.
• Install the dryer in an area where the room temperature is
IMPORTANT:
guide. It contains valuable and helpful information that will
save you time and money.
review the "Avoid Service Checklist" before calling for
service.
future reference.
NOTE
Ecological tips
cycle settings. Choose an automatic dry cycle whenever
possible for accurate drying time.
take longer to dry.
and overdrying.
dryer.
which prolongs drying time.
at least 7°C.