Honeywell Xenon 1910 User Manual page 19

3. If you are connecting a Granit scanner, make sure the cable is pushed tightly into the scanner. Loosen the locking plate
and slide it over the base of the cable connector to lock the cable in place. Tighten the screw.
Note: The power supply must be ordered separately, if needed.
4. If you are connecting a CCB01-010BT Base, make sure the cables are secured in the wireways in the bottom of the
cordless base and the base sits flat on a horizontal surface. If you are connecting a CCB02-100BT Base, see
a CCB02-100BT Base
5. Plug the serial connector into the serial port on your computer. Tighten the two screws to secure the connector to the
port.
6. Once the scanner or cordless base has been fully connected, power up the computer.
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.
CCB01-010BT Base
RS232 Serial Port Connection:
CCB02-100BT Base
RS232 Serial Port Connection:
on page 1-9.
Mounting
1 - 7