Specifications - Mark Levinson 536 Owner's Manual

Nº536 Series Power Amplifier
Caution!
Input & Output Connectors
Control Connectors
Rated Output Power
Frequency Response
Signal-to-Noise Ratio
Input Impedance
Voltage Gain
Input Sensitivity
Power Requirements
Dimensions
• To remove dirt and fingerprints from the amplifier's exterior surface,
use a soft, lint-free cloth. DO NOT use metal polish or a cloth made
with steel wool.
• If needed, this cloth can be dampened with isopropyl alcohol. DO
NOT dampen the cloth with Benzene, acetone-based cleaners, or other
commercial cleaners.
• Wipe the amplifier's exterior surface in the same direction as the grain
of the brushed aluminum.
DO NOT apply liquid directly to the amplifier's exterior surface.
Doing so may damage electrical components.

Specifications

All specifications are subject to change without notice.
• One balanced XLR input
• One unbalanced RCA input
• Two pairs of "Hurricane" loudspeaker outputs with banana-plug sockets
per channel (banana-plug socket not available on the 230 VAC models)
• One Ethernet 10/100 connector
• One 3.5mm mono (tip/sleeve) mini plug trigger input, 12Vdc
• One 3.5mm mono (tip/sleeve) mini plug trigger output, 12Vdc
• 3-pin IEC standard power connector
400Wrms at 8 ohms, 20Hz to 20kHz, at <0.3% THD
10Hz to 20kHz +/-0.2dB
>85dB, reference level: 2.83Vrms
60kΩ (balanced); 30kΩ (unbalanced)
26dB
2.83Vrms output at 142mVrms input
100V~, 120V~, 230V~, factory set for destination country, 1500W
Height (with feet): 7.65" (19.4cm)
Height (without feet): 6.97" (17.7cm)
Width: 17.75" (45.1cm)
Depth: 19.83" (50.4cm)
Weight Net weight: 100lbs (45.4kg)
Shipping weight: 117lbs (53kg)
11