Jeep Grand Cherokee SRT 2015 Operating Information Manual page 62

7. Finally, pull up on any excess webbing to
tighten the lap portion around the child re-
straint while you push the child restraint
rearward and downward into the vehicle
seat.
8. If the child restraint has a top tether strap
and the seating position has a top tether
anchorage, connect the tether strap to the
anchorage and tighten the tether strap. See
the section "Installing Child Restraints Using
the Top Tether Anchorage" for directions to
attach a tether anchor.
9. Test that the child restraint is installed tightly
by pulling back and forth on the child seat at
the seat belt path. It should not move more
than 1 inch (25.4 mm) in any direction.
Any seat belt system will loosen with time, so
check the seat belt occasionally, and pull it tight
if necessary.
Installing Child Restraints Using The Top
Tether Anchorage:
WARNING!
Do not attach a tether strap for a rear-facing car
seat to any location in front of the car seat,
including the seat frame or a tether anchorage.
Only attach the tether strap of a rear-facing car
seat to the tether anchorage that is approved
for that seating position, located behind the top
of the vehicle seat. See the section "Lower
Anchors and Tethers for CHildren (LATCH)
Restraint System" for the location of approved
tether anchorages in
Installing Child Restraints Using the Top
Tether Anchorage
access to the tether anchorage. If there is no
top tether anchorage for that seating position,
move the child restraint to another position in
the vehicle if one is available.
2. To access the top tether strap anchorages
your vehicle.
behind the rear seat, pull the carpeted floor
panel away from the seat back, this will
expose the top tether strap anchorages.
1. Look behind the seating posi-
tion where you plan to install the
child restraint to find the tether an-
chorage. You may need to move
the seat forward to provide better
59