Switching On/Off The Unit; Faceplate Release; Sound Adjustment; Loudness - Pyle PLCD11MRKT Owner's Manual

OPERATION

SWITCHING ON/OFF THE UNIT

Long Press button (1) to turn on the
unit. When the unit is on. Press and hold
button (1) for 2 seconds to turn the
unit off.

FACEPLATE RELEASE

Press release button
removable faceplate.

SOUND ADJUSTMENT

Press SEL button (23) to select the desired
adjustment mode. The adjustment
mode will change in the following order:
BAS-TRE-BAL-FAD-BEEP -LOC-ST-VOL
BAS: bass
TRE: treble
BAL: balance
FAD: fader
BEEP: Beep sound
VOL: volume
LOC: local
ST: stereo
VOL: volume
By rotating the audio knob (23) clockwise or
counter-clockwise, it is possible to adjust the
desired sound quality.

LOUDNESS

Long press the BAND button to active the
LOUD function. Press it and hold again to
cancel this function.
MUTE
Press MUTE button (24) to mute down the
sound instantly. If any button is pressed in
the mute state, the mute state is released.
LOCAL
Press LOC button (3) to select between
local and distant stations.
Local setting for reception of strong station,
and a distant setting for reception of
weaker stations. This function is effect
during SEEK operation.
MONO
Press MON button (4) to select mono or
(2) to detach the
stereo mode. You can sometimes improve
reception of distant stations by selection
EQUALIZATION
Press EQ button (7) to turn on equalization
function and to select desired audio mode.
There are five kinds of mode as below:
→CLAS→POP →ROCK→FLAT→EQ OFF

DISPLAY INFORMATION

Press DSP button (13) to operate as the
conversion of each display mode as
follows:
- In case of receiving a RDS station
In radio mode:
->CT ->FREQ ->PTY -> PS
In CD (MP3/WMA) mode:
->CD (MP3/WMA) ->CT ->FREQ ->PTY
->PS
In case of PTY information, the display
shows as "NO PTY".
- In case of receiving a non RDS station
In radio mode:
-> CT ->FREQ -> „NO PTY‟ -> "NO PS"
In CD mode:
-> CD -> CT -> FREQ -> „NO PTY‟ ->
"NO PS"
Each displaying time is several seconds,
and come back to 1‟st position after several
seconds.
Notes:
- CT = clock time
- FREQ = frequency

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated
functions on the display .

ESP FUNCTION

The unit can be shockproof between ten
seconds and twenty seconds.

RESET FUNCTION

RESET button (27) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
9