Table of Contents
Advertisement
Adding or Changing the clicker
In case you need to add the clicker or replace the clicker due to reasons such as malfunction,
follow the instruction described below.
N o t e
Connect the wireless adapter to your computer before performing the above operation.
Make sure to follow the instruction correctly otherwise the system may not
recognize the added clicker.
Caution
➊
Perform the wireless setting for the added clicker.
Establish the wireless setting between the added clicker and the wireless adapter.
Refer to 〈
Wireless setting for the clicker
Launch ELMO SRS Configurations.
➋
Launch the configuration software.
Select the Clicker Information button
the "SRS" tab to show the list of clickers.
➌
Select the added clicker.
Turn on the added clicker and press one of the
Response buttons on the clicker. Verify that the
Device ID of the added clicker is displayed in blue.
If the Device ID of the added clicker is not displayed,
retry from the step ① "wireless setting".
When adding the clicker, press the OK button to finish.
Register the student, if necessary.
When changing the clicker, continue to the step ④ .
N o t e
The Device ID for the added clicker can be selected by a mouse.
〉 in Various Settings for details.
in
The cell turns to blue when the
Response button of the clicker
is pressed.
OK
button
87
Clicker
Information
Advertisement
Table of Contents
