Replacing The Batteries Of The Clicker; Attach The Clicker Number Sticker (If Necessary) - Elmo CRV-24 Instruction Manual

Replacing the batteries of the clicker

Use the supplied screw driver to loosen
the battery box cover fixing screw.
Remove the battery box cover.
Make sure to attach the cover after
inserting the batteries and tighten the
fixing screw.
・Make sure that the polarity (+/-) of the dry cell battery is correct.
・Remove the dry cell battery if the clicker will not be used for a long time.
・Do not recharge or short-circuit the dry cell battery.
・Use an alkaline dry cell AAA battery. Do not use a rechargeable battery (such
as Ni-Cd).
Caution
・Replace the lid and tighten screw of the battery box after inserting the
batteries.
・Do not mix old and new batteries or ones of different types.
・When disposing of used batteries, follow the instructions from your local
government.
＜Time for replacement of the batteries＞
When the battery level is low, operational performance may be degraded. Replace the
batteries when the power LED begins to flash during power ON or after sending a
response.
・Be careful when replacing the battery because it may pop out.
・Replace the batteries at least once a year.
Caution

Attach the clicker number sticker (if necessary)

Attach the clicker number sticker supplied with this product.
When using a blank sticker, write a desired number on it.
N o t e
By default, a sticker with a number from 1-24( or 32/40) is attached.
18
Alkarine dry
cell AAA
batteries
Clicker number
sticker