Various Settings; Wireless Setting For The Clicker - Elmo CRV-24 Instruction Manual

Various Settings

In this section, you will learn how to configure SRS.

Wireless setting for the clicker

If the wireless connection cannot be established after pressing Response buttons (the
"Response button LED" continues to flash) perform the wireless setting using the "Wireless
setting button" inside the battery box and on the wireless adapter.
・Perform the wireless setting within 30 seconds of pressing the "Wireless
setting button" inside the battery box.
・Hold the body of the wireless adapter when pressing the "Wireless setting
Caution
button" on the wireless adapter.
Turn on the power of the clicker.
Press the "Wireless setting button" inside
the battery box.
[2/B] button flashes at high speed.
Press the "Wireless setting button" on
the wireless adapter.
[1/A] button and [3/C] button on the
clicker flashes a few times. Now wireless
connection between the clicker and the
wireless adapter is established.
N o t e
The wireless setting between the clicker and the wireless adapter was established prior to shipping.
When adding a clicker, the wireless setting for the added clicker needs to be performed before use.
If a clicker is used as described below, wireless connection with the wireless
adapter may become unstable:
- There is an obstruction between the clicker and the wireless adapter.
- The clicker is used while placed on top of a computer.
- A wireless device or electronic equipment is being used nearby.
- The clicker is moved excessively while being used.
- Clickers are used too close with each other.
- Hold the clicker with your hand covering the upper part of it.
Caution
Also, due to the inherent characteristics of the wireless connection, the wireless
connection may become unstable in some positional relationships between the
clicker and the wireless adapter.
↓
↓
↓
↓
Power button
Wireless adapter
70
Battery box