Hitachi C 12LCH Technical Data And Service Manual page 36

F. Digital display (Models C 12LCH/C 12LC)
Tool required:
• Phillips screwdriver
1. Remove the Indication Panel Ass'y [128] and Packing (D) [129] and remove the four Machine Screws (W/
Washers) M4 x 16 [126].
2. Remove the two Machine Screws (W/Washers) M5 x 16 [124] securing Table Insert (A) [122] and remove
Table Insert (A) [122].
3. Disconnect the three connectors and the Machine Screw (W/Washers) M4 x 16 [115] from the Controller [114].
Then the Controller [114] and Monitor Ass'y [173] can be removed from the Turn Table [107].
NOTE: Be careful not to disconnect the flat cable between the Controller [114] and the Monitor Ass'y
[173] when removing from the Turn Table [107].
4. Peel off the silicone from the flat cable between the Controller [114] and the Monitor Ass'y [173] and pull out
the flat cable from the Monitor Ass'y [173]. Then the Controller [114] can be removed. At reassembly, apply a
light coat of silicone (Maker: ShinEtsu, Name: RTV rubber, Model: KE348W) to the connecting portion
between the flat cable and the Monitor Ass'y [173].
Fig. 37
--- 32 ---