CAUTION:
If the figure shown on the miter angle digital display is different from the positive stop angle (for example,
45.0û
45.5û, 31.6û
32.0û) then the positive stop has probably deviated slightly from its correct position.
If this happens, do as follows.
(1) Move the turn table left and right with the side handle loosened, and set the turn table to the correct
position.
(2) If the figures on the display and positive stop still do not match, then return the turn table to the 0û
position. Next move the turn table left and right with the side handle loosened as shown in Fig. 26.
After setting it to the correct position 0û, press the reset button again.
Move the turn table left and right with the side
handle loosened and set it to the correct position.
Fig. 26
--- 21 ---
Reset button
Side handle