PEUGEOT ION Handbook page 97

2. Infl ation
Check that the compressor switch A is in
the "OFF" position.
Uncoil the compressor pipe B.
Connect this pipe to the valve of the
repaired wheel.
Connect the compressor's electric plug to
the vehicle's 12 V socket (ignition switch in
position "ON" or "ACC").
Start the compressor by turning the
switch A to the "ON" position.
Using the compressor, adjust the pressure
in accordance with the vehicle's tyre
pressure label (located in the driver's door
aperture).
A loss of pressure indicates that the
puncture has not been fully plugged;
contact a PEUGEOT dealer or a qualified
workshop for assistance.
Remove the compressor and stow the kit.
Drive off straight away at reduced
speed (50 mph [80 km/h] max) limiting
the distance travelled to approximately
120 miles (200 km).
Practical information
If after around 5 to 7 minutes the
pressure is not attained, this indicates
that the tyre is not repairable; contact
a PEUGEOT dealer or a qualified
workshop for assistance.
As soon as possible, go to a PEUGEOT
dealer or a qualified workshop.
Tell the technician that you have used
the kit. After checking, the technician
will advise you whether the tyre can be
repaired or must be replaced.
8
95