Combination Meter Assembly - Subaru 2001 FORESTER Service Manual

3. Combination Meter
Assembly
S907335
A: REMOVAL
S907335A18
1) Disconnect ground cable from battery.
2) Set tilt steering at the lowest position.
3) Remove screws and detach meter visor.
4) Remove screws of combination meter and pull
out the meter toward you.
5) Disconnect connector in the upper area of com-
bination meter to remove meter.
CAUTION:
¼ Be careful not to damage meter or instru-
ment panel.
¼ Pay particular attention to avoid damaging
the meter glass.

COMBINATION METER ASSEMBLY

S6M0076A
S6M0077
IDI-15
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
¼ Make sure that electrical connector is con-
nected securely.
¼ Make sure that each meter operates nor-
mally.
C: DISASSEMBLY
CAUTION:
Use gloves to avoid damage and getting finger-
prints on the glass surface and meter surfaces.
1) Disengage claw (F) to remove case (B) from
back cover (A).
2) Disengage claw (G) to remove meter glass (E),
reflector (D), and window plate (C) from inner case.
3) Pull up claw (A) of combination meter printed
circuit with combination pliers. Push out speedom-
eter assembly (B) and tachometer assembly (C)
using hole (D).
4) Pull up claw in the center of combination meter
printed circuit and remove combination meter
printed circuit from case (F).
Instrumentation/Driver Info
S907335A11
S907335A06
S6M0511A
S6M0512A