Parts Assembly; Battery; Lens - Recon JET Owner's Manual

PARTS ASSEMBLY

Your Jet smart eyewear comes as a pre-assembled unit. This section shows how to safely detach Jet's components: the
engine, battery, lens, and nosepiece.
WARNING: When removing Jet's engine or battery, always take care to avoid damaging the frame and the other components.

BATTERY

REMOVING THE ENGINE AND BATTERY
1. Gently push the release tab forward with your thumb.
2. With the release tab pushed forward, swing the battery
or engine inward to release it from the frame.
WARNING: Removing the engine or battery while Jet is on or
charging may cause permanent damage.
RE-ATTACHING THE ENGINE AND BATTERY
1. Hold the engine or battery with one hand. Hold the
frame with your other hand.
2. Line up the groove on the engine or battery with the
corresponding lip on the frame.
3. Gently swing the engine or battery outward until
the release tab snaps into the corresponding slot
on the frame.

LENS

REMOVING THE LENS
1. Make sure you remove Jet's engine and battery before
removing the lens. (See above).
2. There is a release tab at the center of Jet's frame. Using
your fingernail, gently pull the release tab all the way
back. This will open the lens release mechanism.
3. Hold the center of the frame with one hand. With your
other hand, grip the nosepiece and nose bridge, then
pull straight down to remove the lens from the frame. If
you have trouble removing the lens, check the release
tab to make sure it's pulled all the way back.
5mm
4