Nosepiece - Recon JET Owner's Manual

REPLACING THE LENS
1. Make sure Jet's lens release tab is fully extended.
2. Insert the lens into Jet's frame, starting with the side
closest to you. Insert only one side at a time, and make
sure the middle part of the lens is all the way in before
you continue.
3. Be careful not to unseat the electric circuit that runs
along the edge of the lens. If the circuit comes loose,
press it back into place.
4. Secure the lens by pushing in the release tab until it sits
flush with the frame.

NOSEPIECE

REMOVING THE NOSEPIECE
1. Hold the lens by its top and bottom edges.
2. Using your other hand, grip one side of the nosepiece
between your thumb and forefinger. Make sure you grip
both the nose pad and the plastic clip.
3. Pull the nosepiece outward in a swiveling motion.
REPLACING THE NOSEPIECE
Align the nosepiece with the gap at the bottom of the lens,
and then gently push the nosepiece in. The nosepiece should
snap into place.
5