Compliance Information - Recon JET Owner's Manual

COMPLIANCE INFORMATION

FCC Compliance Class B Digital Device
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
FCC Declaration of Conformity
Jet (FCC ID: ZW5009) comply with FCC standard CRF 47 Part
15 subpart B and subpart C – section 15.249. Operation is
subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received,
including interference that may cause undesired
operation.
Industry Canada Compliance
Jet was certified with IC numbers 9717A-
009. This device complies with Industry
Canada license exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept
any interference, including interference that may cause
undesired operation of the device.
Cet appareil est conforme avec les normes de l'Industrie
Canada-sans les standards RSS (s). L'utilisation est
soumise aux deux conditionssuivantes: (1) cet appareil ne
peut pas provoquer d'interférences et (2) cet appareil doit
accepter toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement de l'appareil.
Japanese Radio Law and Japanese
Business Law Compliance
Jet (R: 202-SMC093, T: D 14-0053 202) is
granted pursuant to the Japanese Radio Law (ordinance of
MPT No. 37,1981) and the Japanese Business Law (Article
56, Paragraph 1).
The RCM indicates a device's compliance with
applicable ACMA (Australian Communications
and Media Authority) technical standards-
that is, for telecommunications,
radiocommunications, EMC and EME-and with
applicable state and territory electrical equipment safety
requirements.
16